| 1. Remove the central console. |
2. Remove knots and elements in the following sequence:
– combination of devices;
– the central panel and switches from the driver;
– radio receiver;
– hours;
– loudspeakers of the dashboard;
– safety cushion of the driver and its contact;
– screen wiper engine. |
| 3. Remove a steering column. |
| 4. Unscrew screws of fastening of the panel of a heater and remove it from the dashboard. |
|
5. Unscrew nuts of fastening of a plate of installation of the electric socket. |
|
6. Remove a plate of installation of the socket of an electrical wiring of the dashboard from an arm. |
|
|
| 7. Unscrew top (are specified by shooters a photo at the left) and lower (are specified by shooters a photo on the right) bolts of fastening are resistant supports of the dashboard from the driver. |
|
8. Remove a rack of support of the dashboard from the driver. |
|
9. Unscrew 2 screws of fastening of a casing of a heater to the dashboard. |
|
|
| 10. Uncover a ware box. By means of the screw-driver remove the switch (a photo at the left) and a bulb (a photo on the right) illuminations of a ware box and disconnect from them the electric socket. |
|
11. On cars with the conditioner remove the sensor from the top central part of the dashboard. |
|
12. Remove from the sensor an installation plate so that the sensor could pass through an opening in the dashboard. |
|
13. By means of the screw-driver remove a side cap of the dashboard from the passenger. |
|
14. From a motor compartment unscrew the nuts and bolts (are specified by shooters) fixing a suspension bracket of installation of the dashboard to a partition of a motor compartment. |
|
15. In interior of the car unscrew bolts of fastening of the left and right end of the dashboard to an installation suspension bracket. |
|
16. Being careful, remove the panel from a partition of a motor compartment. |
