2.2.3.4.2. Auxiliary driving belt
The mechanism of a tension of an auxiliary driving belt (model with the conditioner)
|
|
1. The square core bent 7,0 mm
2. A square opening on the forward party of a tension pulley with the clown
3. Bolt with the clown of fastening of a tension pulley
4. 8,0 mm an opening for installation of adaptation of an automatic tension of a belt |
Removal, installation and check of a tension of a driving belt is made as well as at cars with petrol engines, except for cars with the conditioner.
Removal, installation and adjustment of a tension of an auxiliary driving belt (model with the conditioner)
| PERFORMANCE ORDER |
| Removal |
| 1. Disconnect the negative plug from the accumulator. |
| 2. Tighten the emergency brake and lift a forward part of the car. Remove the right forward wheel. |
| 3. Unscrew screws, disconnect brackets and remove a protective arch from under the right forward wing for receiving access to a bolt of a pulley of a bent shaft. If necessary remove a forward mudguard. |
| 4. Weaken a bolt of fastening of the clown of a tension pulley (see rice. The mechanism of a tension of an auxiliary driving belt (model with the conditioner)). |
| 5. Insert the square core bent 7,0 mm into a square opening of the clown of the mechanism of a tension. |
| 6. Using a core, turn the eccentric mechanism of a tension before combination of openings in an arm of a pulley of the mechanism of a tension and in a suspension bracket behind an arm. After combination of openings establish in them the corresponding core (a bolt of M8 or a core with a diameter of 8 mm). |
| 7. With the fixed mechanism of a tension turn the clown before full weakening of a belt. Take off a belt. |
| Installation and tension |
8. Establish a driving belt around pulleys in the following order:
– conditioner compressor;
– crankshaft;
– tension mechanism pulley;
– pump of the amplifier of steering;
– generator of alternating current;
– eccentric pulley of the mechanism of a tension. |
| 9. Check correctness of installation of a belt on pulleys. |
| 10. Turn an eccentric pulley of the mechanism of a tension to a driving belt, the fiksaktion is not removed yet. Without changing the provision of an eccentric pulley of the mechanism, tension tighten a fastening bolt. |
| 11. Remove a bolt of fixing of an arm and turn the crankshaft on four turnovers of the direction of its working rotation. |
| 12. Check coaxiality of openings in an arm of the mechanism of a tension and a suspension bracket of installation, repeatedly inserting a bolt. |
| 13. Connect a negative wire to the accumulator, establish an arch of a wheel and a mudguard. Establish a wheel and lower the car. |
|
