9f7e9f0f

5.1.3. Accelerator cable

Removal

PERFORMANCE ORDER
1. In a motor compartment remove an accelerator cable from a cam on the case of throttles, then take an accelerator cable cover from the condensing rubber ring (the arrow specified a clip of an external cover of a cable of an accelerator).
2. Release an accelerator cable on all length from fastening brackets.
3. In interior of the car open a cover of an immobilizer and turn on 90 ° a clamp of a cover of a box with fuses.
4. Disconnect the electric socket from a block, unscrew screws of fastening and remove the lower panel from the driver.
5. Remove a bracket of fastening and disconnect an accelerator cable from the top part of a pedal of an accelerator.
6. Take an accelerator cable cover from a clamp on a suspension bracket of installation of a pedal, then tie a long thin cord to a cable of an accelerator.
7. In a motor compartment take the ring condensing a cable of an accelerator from a partition and take an accelerator cable.
8. Untie a cord from an accelerator cable and leave it in a motor compartment. The cord will be required for the subsequent tightening of a new cable of an accelerator into place.

Installation

PERFORMANCE ORDER
1. Tie a cord to a new cable of an accelerator. Having pulled for the cable which is in interior of the car stretch an accelerator cable through a partition.
2. Untie a cord from an accelerator cable, establish a cable cover in a pedal suspension bracket clamp, and connect a cable of an accelerator to a pedal.
3. Check that the cable of an accelerator is reliably fixed to a pedal then establish the lower part of the panel.
4. In a motor compartment check that the cover of a cable of an accelerator is correctly placed in the condensing ring in a partition, then place a cable on all length in fastening brackets.
5. Pull a flat washer over a cover of a cable and establish in an arm and connect an accelerator cable to a throttle cam.

Adjustment

PERFORMANCE ORDER
1. Remove a clip of fastening of a cover of a cable of an accelerator. Check that the cam of a throttle was in the starting position and moving a cable cover, choose sagging of a cable of an accelerator.
2. In the established provision of a cable establish a fastening clip on an external flute to a cable cover before the rubber condensing ring and a washer.
3. After installation of a clip and a cable on the places only insignificant sagging of a cable of an accelerator has to be observed. While the assistant smoothly presses an accelerator pedal, check that the throttle cam completely turns and comes back to a starting position.