9f7e9f0f

11:19. Draft of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Establish a jack under the external end of the lower lever and lift it so that the spring slightly contracted.
3. Put combination tags between a special washer of an internal hinged bolt and the lower frame. At draft installation these tags will allow to keep the angles of installation of a back wheel.
4. Unscrew a nut of fastening of the spherical hinge of back thirst for a pin and take the spherical hinge from a pin.
5. Unscrew a nut of fastening of an internal hinged bolt and remove a special washer. Take a hinged bolt and remove back draft from the car.
6. Completely clear draft of dirt and an anticorrosive covering. Check its state.

Installation

PERFORMANCE ORDER
1. Clear a carving of a hinged bolt and the spherical hinge and grease the surface of contact of new nuts with Molykote G Rapide Plus lubricant.
2. Establish back draft into place and insert a hinged bolt. Establish on a bolt a special washer so that it correctly was established on a bolt and took place against a ledge on the lower frame. Fix it by a new nut, without tightening finally. Combine the tags made before removal and tighten a fastening bolt the required moment.
3. Install the spherical hinge in a pin and fix by a new nut, tightening it the required moment.
4. If necessary make adjustment of angles of installation of a back wheel.