9f7e9f0f

10:11. Support of a back wheel


Prevention

On models with ABS disconnect the accumulator before any rassoyedineniye of the brake system and repeatedly connect it after full connection of elements of the brake system.


Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Remove brake shoes.
3. Using a G-shaped clip, press a brake hose.
4. Purify dirt around connection of a brake tube and a support. Unscrew a nut and disconnect a brake pipe from a support. Close traffic jams a brake pipe and an opening in a support.
5. Unscrew a bolt of fastening of a support, remove a protective head from the directing plug and unscrew a bolt of the directing finger. Remove a support.

Repair

Repair of a back support is similar to repair of a forward support (cm. subsection 10.10).

Installation

PERFORMANCE ORDER
1. Clear a carving of bolts of the directing fingers and cover them with means against unscrewing (Loctite Frenetanch).
2. Establish a support and screw in bolts of fastening of the directing finger, tightening them the required moment.
3. Install a protective head on the directing plugs.
4. Connect a brake pipe to a support and tighten a connecting nut the required moment. Remove a clip from a brake hose.
5. Establish brake shoes.
6. Remove air from the brake system.
7. Establish a wheel and lower the car.