12:15. Trunk lid


Trunk lid
1. Open a trunk lid and remove the negative plug from the accumulator.
2. Remove percussion caps of fastening of finishing of a trunk lid.
3. Remove finishing.
4. Remove fastening brackets from a protective cover of electric wires on a trunk lid.
5. Disconnect a sheeting of electric wires from the trunk lid hinge.
6. Disconnect electric sockets from electric knots in a trunk lid, noting their arrangement. Tie a cord to the ends of wires and take a plait of wires from a trunk lid. Untie a cord from electric wires, leaving it in a trunk lid.
7. A marker note position of hinges on a trunk lid. Unscrew bolts (are specified by shooters) fastenings of hinges and remove a trunk lid.
8. For unscrewing of hinges of a trunk lid it is necessary to remove the back shelf in interior of the car from a body and to unscrew a bolt of fastening of the hinge (it is specified by an arrow).
Rack of support of a trunk lid
9. Using the small screw-driver, remove brackets of fastening and disconnect spherical hinges of a rack from a body and a trunk lid.


Trunk lid
1. Installation is made in the sequence, the return to removal. At the same time it is necessary to combine hinges of fastening of a trunk lid with earlier made tags.
2. Close a trunk lid and check uniformity of a gap on perimeter of a luggage carrier and if necessary make its adjustment, weakening bolts of fastening of hinges of a trunk lid. After adjustment tighten fastening bolts.