9f7e9f0f

12.7. Rear bumper

Removal and installation

PERFORMANCE ORDER
1. On models the sedan (Saloon) from an internal part of the luggage compartment unscrew fastening screws (are specified by shooters a photo at the left) and remove back finishing of a luggage carrier (a photo on the right).
2. Unscrew screws and remove plates of fastening of the left and right angles of finishing of the luggage compartment.
3. Remove fastening percussion caps (take the central pins then take a percussion cap) and release side finishing of a luggage carrier for access to fastening of a bumper.
4. On models of a komba (Estate) open a back door and remove a basic surface from the basis and lateral faces. Unscrew screws and remove a back plate of finishing. Remove the left and right lower side finishing of a luggage carrier. Remove percussion caps of fastening of side finishing of a luggage carrier to a floor. Release brackets of fastening and remove plastic office for storage.
5. On all models unscrew nuts and remove assembly of ventilation from the right back corner of the luggage compartment.
6. From under the car unscrew screws (are specified by shooters) fastenings of a back part of an insert of a wheel to a bumper.
7. Displace inserts from a bumper and unscrew nuts, the fixing left and right ends of a rear bumper to a body.
8. Unscrew bolts of fastening of a rear bumper to a body.
9. In the luggage compartment unscrew 6 nuts of fastening of the top part of a rear bumper.
10. On models the sedan (Saloon) disconnect the electric socket of illumination of registration plate which is located about the left lamp of a backing.
11. Release the ends of a bumper and remove it from the car, releasing the condensing ring of electric wires of illumination of registration plate from a body.
12. Installation is made in the sequence, the return to removal.